Specifications
120 Z-Family Technical Reference Manual
†Data Card Error :
Access
Can’t read or write to
the PC card
Power cycle the receiver. If problem persists,
replace the PC card.
†Data Card Error :
Update
Can’t update the FAT
(file access table)
Power cycle the receiver. If problem persists,
replace the PC card.
†Data Card Error :
Create
Can’t create the files
for new session so we
can’t record data
Power cycle the receiver. If problem persists,
replace the PC card.
†Data Card Error :
Rename
can’t rename the files
of session
Power cycle the receiver. If problem persists,
replace the PC card.
†Data Card Full <5
min
Not enough space on
the PC card to record
more than five
minutes of data under
current conditions
(satellite number,
recording period,
output information).
Replace data card with one containing available
memory.
†Corrupted FAT File Allocation Table
on PCMCIA card has
been corrupted and
could not be recovered
by the receiver.
Format the card by sending $PASHS,FIL,D,999
or $PASHS,CLM.
Not Receiving Base
Data
Not receiving Carrier
Phase measurements
or Code phase
corrections from the
base receiver
Check serial/radio link with the base. Ensure base
is recording position.
Bad Base Coordinates The position entered
in the base receiver for
CPD operation is not
correct (too far from
computed position)
• Base position was entered wrong on the rover
side. Reenter it.
• The mode in the base receiver was set to not
send BPS, set base to send BPS ($PASHS,
CPD,UBP,1).
• If rover is in “entered base station”
($PASH,CPD,UBP,O). Enter the base position
in the rover via $PASHS,BPS,POS.
• If rover is in “receiver base position” mode
(default or $PASHS,CPD,UBP,1), check link
with base.
• Make sure the base sends base coordinates
($PASHS,BPS,PER,O)
Table 6.56: Receiver Warning Messages (continued)
Warning Definition Action