Specifications

Command/Response Formats 111
Commands
Example: Set a session starting at 0100 that will run for 2 hours.
$PASHS,SES,SET,A,Y,010000,030000,10.0,10,3,0 <enter>
If sleep mode is enabled, the receiver will automatically power on 2 minute prior to session time to
ensure all available satellites are tracked by the time recording starts.
This command applies only to the Z-surveyor and Z-FX receivers.
$PASHQ,SES,c
Query session programming parameters, where c is the optional output serial port.
Example: Query session programming parameter
$PASHQ,SES <enter>
Return message:
START END INT MASK MIN TYPE
A N 00:00:00 00:00:00 020.0 10 3 0
B N 00:00:00 00:00:00 020.0 10 3 0
C N 00:00:00 00:00:00 020.0 10 3 0
D N 00:00:00 00:00:00 020.0 10 3 0
E N 00:00:00 00:00:00 020.0 10 3 0
F N 00:00:00 00:00:00 020.0 10 3 0
G N 00:00:00 00:00:00 020.0 10 3 0
H N 00:00:00 00:00:00 020.0 10 3 0
I N 00:00:00 00:00:00 020.0 10 3 0
J N 00:00:00 00:00:00 020.0 10 3 0
INUSE:N REF:000 OFFSET:00:00 TODAY:000
Table 6.47 on page 111 lists all of the above Parameters in alphabetic order:
Table 6.47: SES Message Structure
Return
Parameters
Description Range
1st Column Session Name A-J
2nd Column Session enabled flag ‘Y’ / ‘N’
3rd Column Session start time (hours, minutes, seconds) hh:mm:ss
4th Column Session end time (hours, minutes, seconds) hh:mm:ss
5th Column Session recording interval (seconds) 0.1-999
6th Column Session elevation mask 0-90