Specifications

110 Z-Family Technical Reference Manual
the current day for session programming to operate. Use the $PASHS,SES,SET to
program individual sessions.
This command and all the other session programming commands applies only to Z-Surveyor and
Z-FX receiver.
Example: Enable session programming parameters with 4 minute daily offset to keep
track of the daily change of the GPS satellite configuration.
$PASHS,SES,PAR,Y,121,0400 <enter>
$PASHS,SES,SET,c1,c2,d3,d4,f5,d6,d7,d8
Set the individual sessions for session programming. This command will set a single
session. Up to 10 sessions may be programmed. This command must be used with
$PASHS,SES,PAR.
Table 6.45: SES,PAR Message Structure
Setting parameter Description Range
c1 Session in use
Y = Yes
N = No
S = Sleep Mode
Y or N or S
d2 Session reference day 0-366
d3 Session offset (mm:ss) 0-59
Table 6.46: SES,SET Message Structure
Setting
parameter
Description Range
c1 Session name A-J
c2 Session flag Y = Yes
N = No
d3 Session start time (hhmmss) hh = 0-23
mm = ss = 0-59
d4 Session end time (hhmmss) hh = 0-23
mm = ss = 0-59
f5 Session record interval 0.1-999
d6 Session Elevation Mask 0-90
d7 Session min SV 1-9
d8 Session data type 0, 2, or 4