Specifications

106 Z-Family Technical Reference Manual
PWR: Sleep Mode
$PASHS,PWR,off
Direct the receiver to immediately go into sleep mode. Once a receiver is in sleep
mode, any character issued through any port will restore normal operation.
Example: Put receiver into sleep mode
$PASHS,PWR,OFF <enter>
This command doesn’t apply to Z-Eurocard since the power supply is external to the board.
RCI: Recording Interval
$PASHS,RCI,f1
Set the value of the interval for data recording and raw data output, where f1 is any
value between 0.1 and 999. Values between 0.1 and 1 can increment in 0.1 secs.
Values between 1 and 999 can increment in 1 second. The default is 20.0.
Example: Set recording interval to 5 seconds
$PASHS,RCI,5 <enter>
If the fast data option (F) is not installed, the setting 0.1 second is not available. All other settings (0.2
to 999) are available except 0.7 which is never available.
REC: Data Recording
$PASHS,REC,c
Data recording switch that turns data recording to either Yes, No, Stop, or Restart.
Yes and No are used to enable/disable data recording. The default is Yes. Stop is used
prior to removing a PCMCIA card from the receiver while the receiver is recording
data. This will prevent any corruption of the data files on the PCMCIA card. When
Table 6.40: Baud Rate Codes
Code Baud Rate Code Baud Rate
0 300 5 9600
1 600 6 19200
2 1200 7 38400
3 2400 8 56800
4 4800 9 115200