Instruction manual

Page 74 Z-12 Real-Time Sensor Operation and Reference Manual
THIS COORDINATES
XMIT INTVL
Broadcast interval for BPS message. BPS message
contains base station ground mark coordinates (if
relevant) and antenna offset from reference point. This
command is relevant only for base or RBP rover mode.
30 seconds
ADVANCED PARAMS/
AMBIGUITY FIX MODE
Confidence level for reliability of ambiguity fixed
solution. (See $PASHS,CPD,AFP for details)
4
RTCM DIFFERENTIAL MODE SELECTION
MODE Differential mode setting (Disabled/Base/Remote Disabled
AUTO DIFF If automatic, switch position computation from
differntial to stand-alone
Auto Diff Off
OUTPUT PORT Port to output differential data Port A
CODE C?A code/L1 P-code/RTCM differential C/A code
QAFREQ Communication quality between base station and user
equipment. Not used in base mode. This number is a
percent of the parity passed messages.
SPD Output message speed (not used in REMOTE) 0050
FREQ (TYPE 1) Frequency message type 1:
0=no message
1-98=number of seconds between messages
99=send message continuously
99
FREQ (TYPE 2) Frequency message type 2
0=no message
1-98=number of minutes between messages
99=send message continuously
00
FREQ (TYPE 3) Same as type 1 00
FREQ (TYPE 16) Same as type 1 00
TYPE 6 Enable/disable message type 6 Enable
FREQ (TYPE 18/19) Compatibility:
A=Ashtech
B=Trimble
A
MAX AGE Remote mode, maximum age of messages in seconds 60
SEQ Check sequence number in a message (remote only):
Y=yes N=No
N
MESSAGE Text message sent from base to user equipment None
PORT SETUP - SERIAL PORT SETTING AND MESSAGE SENT THROUGH IT
NMEA Enable/disable NMEA message Disable
INTERVAL NMEA message send interval
REAL TIME Enable/disable real-time output Disable
Table 4.21: Parameters Reset by RST Command (continued)
Parameter Description Default Value