Instruction manual

Page 70 Z-12 Real-Time Sensor Operation and Reference Manual
Reboot
$PASHS,RBT
Clear (reboot) internal RAM and reset sensor. Resets baud rate to 9600 baud.
The structure is $PASHS,RBT.
Set Recording Interval
$PASHS,RCI
This command sets the value of the interval during which raw data will be output or
recorded. The command structure is
$PASHS,RCI,x
where x is an integer number between 1 and 999 seconds. Default is 20.0. With the Q
option installed, the RCI values are as listed in .
Example: Set recording interval to 5.0 seconds
$PASHS,RCI,5.0
Be aware that if the 0.2 and 0.5-second modulations are used, the data cannot be post-processed;
data can be post-processed only if the integer intervals are used. For example, 1,3,5 seconds can be
used for post-processing, while 0.2, 0.5, 1.5, etc. cannot be used for post-processing. Refer to “Query
Radio Mode Parameters” on page 70.
Query Radio Mode Parameters
$PASHQ,RDP
This command asks for the RDP message, which contains information about current
radio mode parameters. The port for message output may be specified in this
command. If the port is not specified, the message is output to the port from which
this command was received. The command structure is
$PASHQ,RDP,x where x is the port for message output, port A or B
Table 4.19: RCI Structure
Field Description
x Output port A or B
mmm Modem mode TRS
cc Channel 0-15
llll RF link speed 4800 or 9600
r RF sensitivity (squelch) 0,1,1