Manualshelf

Instruction manual

ManualsBrandsashtech ManualsGPSZ-sensor
141142143144145146147148149150
Page 127 Z-12 Real-Time Sensor Operation and Reference Manual
Set Health of Reference Station
$PASHS,RTC,STH
This command sets the health of the reference station. The command structure is
$PASHS,RTC,STH,x where x is any value between 0 and 7. Used only in BASE
mode. Default is 0. The codes for the station health are definedby RTCM as listed in
Table 4.77.
Example: Set health to "Reference station not working"
$PASHS,RTC,STH,7
Enable Type of Message
$PASHS,RTC,TYP
This command enables the type of message to be sent by the base station, and the
period that it will be sent. The command structure is $PASHS,RTC,TYP,x,y where
Table 4.77: Station Health Codes
Code Health Indication
7 Reference station not working.
6 Reference station transmission not monitored.
5 Specified by service provider.
4 Specified by service provider.
3 Specified by service provider.
2 Specified by service provider.
1 Specified by service provider.
0 Specified by service provider.