Product Manual

15
Introduction
You can then freely use the Scroll button to access other
receiver screens without affecting the ATL data collection
in progress (pressing the Scroll button from this screen
will take you back to the General Status screen).
• When enough ATL data have been recorded (Tech Support
will usually indicate the duration of ATL data collection
needed for troubleshooting), then come back to the ATL
Recording screen and simply press on the Log button
again to stop the recording.
NOTE 1: ATL data recording is totally independent of raw
data recording: controlling ATL recording is done exclusively
from the ATL recording screen, and raw data recording from
any other screen.
NOTE 2: Before connecting a USB key to record ATL data,
make sure there is no *.par files saved on the key as the
presence of this type of file would initiate some other
functions in the receiver (refer to .
Screen Backlight The screen backlight is automatically turned off if no key is
pressed for 1 minute. When the backlight is off, a short press
on the Scroll button will turn it back on. The Scroll button will
then recover its usual functions.
Data Transfer
Screen
For more information on the screen displayed when
downloading files, refer to Downloading Raw Data on
page 37.
Charging Batteries Before Use
Make sure the battery is fully charged for each ProMark 800
you will be using in the field. Follow the instructions below to
charge a battery.
Removing the
Battery from the
ProMark 800
Unless the battery has already been taken out, do the
following:
• Put the ProMark 800 upside down.