Specifications

Operating Manual - ne8800, ne4800, ne4400
14
11. SPECIFICATIONS
Overall Sonic Performance . . . . . . . . . . . . . . . . Analog in, digital out Digital in, analog out Analog in, analog out
2
Digital in, digital out
Frequency Response, 20 Hz – 20 kHz: . . . . . . . . . . . . . .+/- 0.1 dB +/-0.25 dB +/- 0.25 dB NA
3
Dynamic Range, 20Hz-20kHz, unweighted: . . . . . . . . . .> 115 dB > 114 dB > 114 dB NA
3
THD+N, 1kHz, +20dBu analog (-1dBFS digital): . . . . .< 0.001 % < 0.002 % < 0.002 % < 0.00001 %
Latency at 48 KHz (96 kHz)
4
: . . . . . . . . . . . . . . . . . . . . .1.42 ms (0.71 ms) 0.90 ms (0.45 ms) 2.21 ms (1.11 ms) 0.10 ms (0.05 ms)
Notes:
1) Measured 20 Hz – 20 kHz unweighted using AES17 LPF at 48 kHz sample rate.
2) Analog in to analog out measured using internal master clock.
3) Zero noise or signal amplitude variation introducted in digital domain.
4) Latency of network audio link is additional to latency of digital audio processor.
Audio Inputs . . . . . . . . . . . . . . . . . . . Analog Line/Mic AES3 Digital
Input Type: . . . . . . . . . . . . . . . . . . . . . . Active balanced Euroblock Transformer balanced female XLR
Input Impedance: . . . . . . . . . . . . . . . . . 20k ohms 110 ohms
Max Input Level: . . . . . . . . . . . . . . . . . +20 dBu 7.0 Vpp
Audio Outputs
Output Type:. . . . . . . . . . . . . . . . . . . . . Servo-balanced Euroblock AES3 Transformer balanced male XLR
Output Impedance:. . . . . . . . . . . . . . . . 20 ohms 110 ohms
Max Output Level: . . . . . . . . . . . . . . . . +20dBu 5.0 Vpp
Word Clock
Input/output Type: . . . . . . . . . . . . . . . . 75 ohm BNC
Lock Range: . . . . . . . . . . . . . . . . . . . . . 48 kHz +/- 4%, 96 kHz +/- 4%
Input Impedance: . . . . . . . . . . . . . . . . . Selectable 75 ohm or high-impedance
Input Voltage Range: . . . . . . . . . . . . . . 1.0 Vpp – 7.0 Vpp
Output Impedance:. . . . . . . . . . . . . . . . 75 ohm
Output Level: . . . . . . . . . . . . . . . . . . . . 5.0 Vpp nomimal, unterminated
Master Clock
Sources: . . . . . . . . . . . . . . . . . . . . . . . . Audio network, Word clock, AES3, Internal crystal clock
Modes: . . . . . . . . . . . . . . . . . . . . . . . . . Prioritized auto switching or manual
Digital Audio Hardware
Samples Rates:. . . . . . . . . . . . . . . . . . . 48 kHz, 96 kHz
DSP Processing: . . . . . . . . . . . . . . . . . 32-bit floating-point Sharc processor array
Audio Input Source Selection: . . . . . . . Selectable in adjacent channel pairs from analog, digital, or network inputs
Network Audio Routing:. . . . . . . . . . . . Selectable between input/output or internal to matrix mixer
Digital Audio Output Jitter:. . . . . . . . . 0.5 ns average, 1.0 ns peak
Digital Control
Ethernet Control . . . . . . . . . . . . . . . . . Standard RJ45 10/100 Ethernet with auto-configuration
RS-232 Control . . . . . . . . . . . . . . . . . . Standard female Dsub9 jack (RS-232 control protocol document for Ashly NE products is available on Ashly website)
4-pin active remote. . . . . . . . . . . . . . . . 4-pin Euroblock for phantom-powered bi-directional remotes
Logic Inputs . . . . . . . . . . . . . . . . . . . . . 9-pin Euroblock for (8) assignable 5V logic inputs
Logic Outputs. . . . . . . . . . . . . . . . . . . . Shared with logic inputs. +12V at 10mA output high, 100mA input low
Analog Control
Remote attenuators . . . . . . . . . . . . . . . 10-pin Euroblock for (8) assignable 0-5 VDC passive remote attenuators
Power Requirements: . . . . . . . . . . . . . 90-240 VAC, 50-60 Hz, 70W maximum
Shipping Weight:. . . . . . . . . . . . . . . . . 14 lbs. (6.35 kg)
Dimensions:. . . . . . . . . . . . . . . . . . . . . 19.0” L x 3.5” H x 8.5” D (48.26 cm x 8.89 cm x 21.59 cm)
Environmental: . . . . . . . . . . . . . . . . . . 40-120 deg. F, (4-49 deg, C), noncondensing