Specifications

Operating Manual - FR-8 and FR-16 Remote Level Controller

Front Panel

1) Push Button LED Label Window - Insert

label made from Ashly template doc (page 12)

2) Push Button LED - Used to switch fader

Mute or fader A/B Source Select. LED also

indicates signal level or fader status

3) Channel Fader - Adjusts level of targeted

DSP gain stage or output mixer source

4) Channel Fader Label Window - Insert

label made from Ashly template doc (page 12)

5) Power LED - Shows device is powered

6) Master Fader - Adjusts level of all

assigned channel faders

Rear Panel

1) RJ-45 Jack - Connects to Ethernet

Network with PoE or PoE injector

2) Link LED - Shows network is connected

3) Data LED - Shows Data is transferring

4) Lockout Connector - Use with any switch

to disable all front panel controls when closed

5) Serial Number and MAC Address - Used

for warranty or ash programming

 FR Features (FR-8 not shown)

On Startup:

1. When the FR-8 or FR-16 is first connected or powered on, it attempts to communicate with

all devices it has been programmed to control, if any.

2. Once communication with the targeted device is established, it waits to transmit any fader or

switch position data until a control is physically changed by the user. At that point only the data for

that control is sent. This feature prevents sudden and unexpected changes when reconnecting or re-

starting the FR remote control, as well as when a new preset is recalled to the host device.

PLEASE NOTE: When in doubt, make sure all faders are either in the correct position or fully

down before reconnecting