User guide

101B224-01 DIN-Rail Mounting Kit Instruction Manual
5
Firmly press down on clip for
10 seconds. Repeat this pro-
cedure on opposite side. Once
clips are properly installed, the
modules with clips mounted
should look similar to one or
both of the modules pictured
to the right. While the adhe-
sive is initially quite strong, this
strength improves signicantly
over a period of approximately
12 hours.
Communications Module Example
Hinge End
Latch End
Peel the protective layer off
of the adhesive tape on the
bottom of one of the mount-
ing clips. With the hinge end
of the clip (see below) facing
the end of the module with the
communications connector,
align the clip along the long
(side) edge of the module and
centered lengthwise within the
at surface of the module.
Completed Assemblies