Installation and Maintenance Instructions for 101B224-01 DIN-Rail Mounting Kit Ashcroft Inc. 250 East Main Street, Stratford, CT 06614 USA Tel: 203-378-8281, Fax: 203-385-0402 www.ashcroft.com All sales subject to standard terms and conditions of sale. © 2012 Ashcroft Inc.
101B224-01 DIN-Rail Mounting Kit Instruction Manual Disclaimer The information contained in this document is subject to change without notice. Ashcroft makes no representations or warranties with respect to the contents hereof, and specifically disclaims any implied warranties of merchantability or fitness for a particular purpose. © 2012 Ashcroft Inc. All rights reserved.
101B224-01 DIN-Rail Mounting Kit Instruction Manual Compatible Devices The 101B224-01 DIN-rail mounting kit can be used with the following Ashcroft modules. Model Description 101B224-03 DproM 4 Relays Module 101B224-04 DproM Digital I/O Module (4 In & 4 Out) 101B224-06 DproM RS-232 Serial Adapter 101B224-07 DproM RS-485 Serial Adapter Visit our Web Site http://www.ashcroft.
101B224-01 DIN-Rail Mounting Kit Instruction Manual The mounting kit includes (1) 6" length of DIN-rail, (4) mounting clips, and this instruction sheet. It contains enough parts to mount 2 modules. Please read the instructions thoroughly before proceeding. Instructions Locking Tab Slot Step 1 Mounting the DIN-rail clips to the module. Place the expansion module on a flat surface with the bottom surface facing up.
101B224-01 DIN-Rail Mounting Kit Instruction Manual Peel the protective layer off of the adhesive tape on the bottom of one of the mounting clips. With the hinge end of the clip (see below) facing the end of the module with the communications connector, align the clip along the long (side) edge of the module and Communications Module Example centered lengthwise within the flat surface of the module. Latch End Hinge End Firmly press down on clip for 10 seconds. Repeat this procedure on opposite side.
101B224-01 DIN-Rail Mounting Kit Instruction Manual Step 2 Mounting the DIN-rail to your panel. The DproM modules are very light (approx. 1½ oz each). As such, the mounting hardware does not need to be very strong. We recommend two #10 pan head screw (shown to the right), but only because it best accommodates the slots in the DIN-rail. Do consider any strain your wiring might place on the module mounting.
101B224-01 DIN-Rail Mounting Kit Instruction Manual Step 3 Mounting modules to DINrail. To mount modules to DINrail, first locate the approximate position you would like to place the module on the DIN-rail, then hook hinge end of mounting clip to edge of DIN-rail as shown to the right. Then lower the opposite “latch end” of the clip onto the rail. Press down on the module until the latch end snaps in place.
Ashcroft Inc. 250 East Main Street, Stratford, CT 06614 USA Tel: 203-378-8281, Fax: 203-385-0402 www.ashcroft.com All sales subject to standard terms and conditions of sale. © 2012 Ashcroft Inc.
