Specifications

Guide to Dan Wesson
16101, 16182, 16183, 17115, 17176, 17177
Procedure for mounting of gasket repair kit – 17131
Side 2 – NC – 001 - 2012
3. Removal of cover plate:
a. The cover plate can be lifted straight up
b. Do not tilt the plate while lifting it off the gun
4. Removal of hammer:
a. The hammer can be lifted straight up
b. Mind the spring while lifting the hammer
c. Hold as shown on the picture
5. Removal of valve section:
a. Remove the 4 screws with the PH1 driver
6. Removal of valve section:
a. Lift the valve straight up of the holding pin
7. Removal outer gasket:
a. Unscrew the holding ring with the flat driver
b. Take care not to break the ring!