English Asema M2 User Manual
Asema M2 User Manual Asema Electronics Ltd Copyright © 2011-2012 No part of this publication may be reproduced, published, stored in an electronic database, or transmitted, in any form or by any means, electronic, mechanical, recording, or otherwise, for any purpose, without the prior written permission from Asema Electronics Ltd. Asema E is a registered trademark of Asema Electronics Ltd.
Table of Contents Safety .................................................................................................................................. 1. Installation ....................................................................................................................... 1.1. Locating the leads and attaching the clamps ......................................................... 1.2. Connecting to power ........................................................................................
Safety Please read this before proceeding and follow the safety precautions below when installing and operating the system. Retain and follow all product safety and operating instructions. Observe all warnings in the operating instructions on the product. Operate your appliances responsibly, especially when controlling them with remote controls or over the Internet. Remote control of appliances in an Asema system is disabled by default to prevent accidental damage.
1. Installation Important The Asema M2 should be installed by a qualified electrician only. 1.1. Locating the leads and attaching the clamps Locate the three incoming phases in the fuse box, going to the main fuse/power switch. Attach the current clamps onto the leads as indicated by the installation diagram on the device. The clamps are attached to the lead only, do not attach them to the neutral.
2. Pairing and communicating with Asema E In order for the Asema E to communicate with the Asema M series meters, they need to be paired first. After pairing the Asema E can receive power measurement data in an encrypted format for maximum privacy and security. Pairing can be done either using the touchscreen of the Asema E, or in the WebView. 2.1. Pairing the meter To pair the meter with Asema E, first enter the Main setup. Then proceed as follows. 1. At the main setup go to Appliances->Central Meter. 2.
2.4. Resetting the meter Each Asema M series device has a dedicated reset button for removing pairing data from the meter itself manually. You should always try to reset the meter from the Asema E first before doing a manual reset. A manual reset will simply remove the pairing from the meter without telling about this to an Asema E. It will therefore result in a "ghost" meter on the Asema E that can no longer be reached. You can however remove it from the Advanced settings of the meter on Asema E.
3. Troubleshooting This section lists a few common problems you may encounter into while using your Asema M meter and common remedies to them. For a more complete list of howto's and up-to-date answers to problems, visit the FAQ section on our support website at support.asema.com.
Recycling At the end of its serviceable life, this product should not be treated as household or general waste. It should be handed over to the applicable collection point for recycling of electrical and electronic equipment, or returned to the supplier for disposal. You are liable to dispose of all your electronic or electrical waste equipment by relocating over to the specified collection point for recycling of such hazardous waste.
