Operating instructions

TD 92579GB

2009-04-15/ Ver. B

Installation and Operation Manual

IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)

8.7.2 Device Management

If a specific Device Manager (e.g. WSM) is to be used in the Ascom IP-DECT system, enter

the IP address to the Device Manager following the steps below. To set the Master to

search for an existing Device Manager on the network, go to 8.7.3 Service Discovery on

page 81.

1 Select UNITE > Device Management.

Note: To access the Device Management tab, the Master mode has to be activated,

see

8.5.12 Select Mode on page 70.

2 Enter the address to the Device Manager in the Unite IP Address text field.

The IP address for the Device Manager that the Master is currently connected to is

shown under Active Settings.

3 Click "OK".

8.7.3 Service Discovery

If no Device Manager (e.g. WSM) has been selected to be used in the Ascom IP-DECT

system, see 8.7.2 Device Management on page 81, then the Master will automatically

search for an existing Device Manager on the network. To set the Master to search in a

specific domain on the network or to stop the search, follow the steps below.

1 Select UNITE > Service Discovery.

Note: To access the Service Discovery tab, the Master mode has to be activated, see

8.5.12 Select Mode on page 70.

2 Do one of the following:

• To stop the Master to search for a Device Manager, select the Disable check box.

• To set the Master to search for a Device Manager in a specific domain on the

network, enter the domain id in the Domain ID text field. The domain id must be

the same as the one entered in the Device Manager.

3 Click "OK".

8.7.4 Send Status Log

It is possible to send alarm and event reports to the Unite system. For example directly to

the ESS fault handler or the UNA (Unite Node Assistant) which in turn forwards the alarm

event according to its distribution list.

1 Select UNITE > Status Log.

2 Enter the address to the server where the Status Log should be sent in the Unite IP

Address text field.

3 Enter the Resource Identity/service in the Unite Resource Identity text field. If this

field is left empty then the default will be UNA (Unite Node Assistant).

8.8 Users

This section describes the Users sub menu and how to do the following:

• Add a user.

• Search for user information.

• Show all registered users in the IP-DECT system.