Operating instructions

TD 92579GB
2009-04-15/ Ver. B
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)
74
4 Enter the address to the Mobility Master in the IP Address text field.
5 Enter the address to the Standby Mobility Master in the Alt. IP Address text field.
6 Click "OK".
7 Reset in order to make the changes take effect, see 8.16 Reset on page 113.
8.5.20 Enable the Radio
1 Select DECT > Radio.
2 Clear the Disable check box.
8.5.21 Enter IP Address to the Pari Master and the Standby Pari Master
All IPBS/IPBLs need to know the IP address of the Pari Master and the Standby Pari Master.
1 Select DECT > Radio.
2 Write the name for the Pari Master in the Name text field.
3 Enter the password for the Pari Master in the Password text field.
4 Enter the address to the Pari Master in the Pari Master IP Address text field. If this is
the Pari Master, enter 127.0.0.1.
5 Enter the address to the Standby Pari Master in the Standby Pari Master IP Address
text field. If this is the Standby Pari Master, enter 127.0.0.1.
6 Click "OK".
7 Reset in order to make the changes take effect, see 8.16 Reset on page 113.
8.5.22 Multiple Radio Configuration
The PARI Master can configure the same Radio settings for all Radios in the system. All
settings configured in the Radio Config page replace the local Radio settings.
1 Select DECT > Radio Config.
Note: To access the Radio Config. tab, the Pari function has to be enabled, see
8.5.14 Enable Pari Function on page 71.
2 Configure alarm and event forwarding, see Forward Alarms and Events on page 50.
3 Configure automatic firmware update, see 8.1.3 Configure Automatic Firmware
Update on page 47.
4 Configure NTP settings, see 8.1.4 Configure the NTP Settings on page 48.
5 Configure IP settings, see 8.3.1 Configure IP Settings on page 59.
6 Click "OK".
8.5.23 PARI
The PARI is a part of the broadcast identity, which uniquely identifies an IPBS/IPBL. This
PARI is automatically assigned to each IPBS/IPBL in the system. But if more than one Ascom
IP-DECT system operates within the same coverage area, the systems need to have a
unique system identity in the PARI assigned in order to differentiate the systems.
To see the occupied system IDs of other Ascom IP-DECT systems within the coverage area,
perform an RFP scan, see 8.12 Backup on page 103.