Operating instructions

TD 92579GB

2009-04-15/ Ver. B

Installation and Operation Manual

IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)

3 If you have selected the "Standby" mode enter the primary Master IP address in its

text field.

4 Click "OK".

5 Reset in order to make the changes take effect, see 8.16 Reset on page 113.

8.5.13 Set Master Id

1 Select DECT > Master.

2 Enter a Master id in the Master Id field. The id must be unique for each Master in a

multiple Master system. The Standby Master must have the same id as the Master.

3 Reset in order to make the changes take effect, see 8.16 Reset on page 113.

8.5.14 Enable Pari Function

The Pari Master is responsible for assigning PARIs, being part of the same external

handover domain, to the Radios associated. A Radio will always be given the same PARI,

based on the PARI-mac-address-association.

1 Select DECT > Master.

2 If this is the Pari Master, select the Enable Pari function check box.

Note: Only one Master per handover and sync domain can have the Pari function

enabled.

3 Reset in order to make the changes take effect, see 8.16 Reset on page 113.

8.5.15 Configure Gatekeeper

The Master need to know the address to the system gatekeeper.

1 Select DECT > Master.

2 In the drop-down list, select "H.323" or "SIP" protocol.

If "H323" protocol is selected, continue with step 3 and 4. Otherwise, jump to step

3 Enter the address to the gatekeeper in the Gatekeeper IP address text field.

4 Enter the address to the alternative gatekeeper in the Alt-Gatekeeper IP address

text field.

Note: As an alternative to the Gatekeeper IP Address, the Gatekeeper ID can be

used.

5 Note: Step 5 to 7 applies to SIP protocol.

Enter the IP address or host name and optionally port of proxy (e.g.

proxy1.example.com:5060) to the SIP proxy (registrar) in the Proxy text field.

6 Enter the IP address or host name and optionally port of proxy (e.g.

proxy2.example.com:5060) to the alternative SIP proxy (registrar) in the Alt. Proxy

text field.

7 If used, enter the domain address in the Domain text field.

8 Enter the maximum internal number length in the Max. internal number length text

field.

9 To enable "Enbloc Dialling", select the Enbloc Dialling check box.

With this option enabled the keystrokes on the handsets are buffered in the IPBS/

IPBL for a short period of time before sent to the IP-PBX (use this when the IP-PBX