Operating instructions

TD 92579GB

2009-04-15/ Ver. B

Installation and Operation Manual

IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)

1 Select DECT > System.

Note: To access the System tab, the Master mode has to be activated, see 8.5.12

Select Mode on page 70.

2 Choose language in the Default Language drop-down list.

3 Click "OK".

8.5.6 Set Frequency Band

The IPBS/IPBL can operate in the following frequency bands:

• 1880 - 1900 MHz, Europe, Africa, Middle East, Australia, New Zeeland and Asia

• 1910 - 1930 MHz, South America

• 1920 - 1930 MHz, North America

Figure 41 .

1 Select DECT > System.

Note: To access the System tab, the Master mode has to be activated, see 8.5.12

Select Mode on page 70.

2 Select frequency area in the Frequency drop-down list.

3 Click "OK".

4 Reset in order to make the changes take effect, see 8.16 Reset on page 113.

8.5.7 Enable Carriers

The IPBS/IPBL has 5 carriers for the North American frequency band and 10 carriers for the

other frequency bands. Under all normal circumstances all carriers should be enabled.

To enable or disable carriers:

1 Select DECT > System.

Note: To access the System tab, the Master mode has to be activated, see 8.5.12

Select Mode on page 70.

2 Select/clear the Enabled Carriers check boxes.

3 Click "OK".

8.5.8 Local R-Key Handling

With this option enabled keypad information is handled locally. If this option is disabled

keypad information is sent transparently to the IP-PBX. Local R-key handling is further

described in Appendix C.

1 Select DECT > System.

Note: To access the System tab, the Master mode has to be activated, see 8.5.12

Select Mode on page 70.

2 To enable, select the Local R-Key Handling check box.

3 Click "OK".

8.5.9 No Transfer on Hangup

If enabled it will not be possible to do a transfer by hanging up the phone. R4 must be

pressed (see Appendix C).