Operating instructions

TD 92579GB
2009-04-15/ Ver. B
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)
59
8.3 IP
8.3.1 Configure IP Settings
The following settings can be done in the IP settings sub menu:
1 Select IP > Settings.
2 Enter the ToS priority value (recommended value is "0xb8") in the ToS Priority - RTP
Data text field.
3 Enter the ToS priority value (recommended value is "0x68") in the ToS Priority - VoIP
Signalling text field.
4 Select which ports to use for RTP traffic by entering the first port in the First UDP-
RTP Port text field.
5 Enter the number of ports to use in the Number of Ports text field.
6 Click "OK".
8.3.2 Routing
View the IP routing by Select IP > Routing.
8.4 LDAP
The Lightweight Directory Access Protocol (LDAP) protocol is required for systems in which
the server and a replicating client access a joint user database.
The joint user database contains information about the users registered in the system. It
also contains the system configuration, that is the configurations made under the "DECT"
menu.
This section describes how to do the following configurations and settings.
• Configure LDAP Server
• Check LDAP Server Status
• Configure LDAP Replicator
• Check LDAP Replicator Status
ToS priority,
RTP Data and VoIP Signalling:
Determines the priority from the ToS field in the IP
header. This function can be used if the router can
use ToS priority control.
Hexadecimal, octal or decimal values can be used;
0x10, 020 and 16 are all equivalent.
There are two fields for ToS priority, one for RTP
Data and one for VoIP Signalling
a
. Other types of
traffic (for example http and ldap) are not prioritized
and use 0x00.
Note: Remember that the same value should be set
in the ToS field for all devices.
a. VoIP Signalling includes roaming, handover, registrations towards the IP-PBX etc.
RTP ports: If the ports fields are left blank, the ports 16384 to
32767 will be used.