Operating instructions

TD 92579GB
2009-04-15/ Ver. B
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)
57
8.2 LAN
This section describes how to do the following configurations and settings.
• Set DHCP mode
• Set IP static address
• Set dynamic IP address
• Set link type
• Configure VLAN
• View LAN statistics
Note: The IPBL has two LAN ports. LAN1 port must be used in the IP-DECT system (LAN2
port is for administration only).
8.2.1 Set DHCP Mode
The IPBS/IPBL can have different DHCP modes, see the table below.
Figure 37 .
Change DCHP mode following the steps below.
1 Select LAN > DHCP.
2 Select DHCP mode in the Mode drop-down list.
3 Click “OK”.
4 Reset in order to make the changes take effect if "Client" or "Automatic" is set,
see
8.16 Reset on page 113.
8.2.2 Set a Static IP Address
It is necessary for the Master and the Standby Master to have static IP addresses. The
Radios can have dynamic IP addresses retrieved from the network DHCP server.
Ask the network administrator to reserve an IP address for the Master and Standby Master.
1 Select LAN > DHCP.
2 Select “Disabled” in the Mode drop-down list.
3 Click “OK”.
4 Do NOT reset the device yet. Set a static IP address first.
5 Select LAN > IP.
6 Enter "IP Address", "Network Mask", "Default Gateway" and "DNS Server"
addresses provided by the network administrator in the text fields.
You can also enter an alternative DNS Server in the Alt. DNS Server text field and
select the Check ARP check box to detect and prevent ARP poisoning attacks.
Disabled Used if the IPBS/IPBL should have a static IP address.
Client The IPBS/IPBL acts as a DHCP Client, if there is a DHCP server in
the network it will be assigned an IP address
Automatic In automatic DHCP mode the IPBS/IPBL will act as a DHCP
client on power up.
If the IPBS/IPBL is restarted by shortly pressing the reset button
it will get the IP address 192.168.0.1 and the netmask
255.255.255.0 for the LAN1 port.