Manualshelf

Operating instructions

ManualsBrandsASCOM ManualsComputer equipmentTD 92375GB
41424344454647484950
TD 92579GB
2009-04-15/ Ver. B
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)
43
8 Reset in order to make the configuration changes take effect, see 8.16 Reset on
page 113.
9 Save the configuration of the Radio, see 8.12 Backup on page 103.
Configure the rest of the IPBS/IPBLs following the steps below:
Note: Uploading the same configuration to all Radios can only be done if the DHCP is set
to client.
1 Determine the address.
2 Select Update > Config and browse to the previously saved configuration. Click
"OK".
3 Reset in order to make the configuration changes take effect, see 8.16 Reset on
page 113.
4 Repeat step 1 to 3 for all Radios.
7.12 Add Users
This section describes how to add users to the IP-DECT system. There are two ways to
register Portable Devices:
• Using the Portable Device to automatically associate the IPEI number to a user, see
7.12.1 Anonymous Registration on page 43.
• Entering the IPEI number of the Portable Device manually, see 7.12.2 Individual
Registration on page 44.
7.12.1 Anonymous Registration
The IPEI, which is the unique identification number of the Portable Device, can be assigned
automatically to a user. This is used to avoid having to enter the IPEI number manually.
Add users in the IP-DECT System
1 Under the Administration menu, select Users.
2 Click "New".
3 Enter the following information in the corresponding text fields, leave the IPEI and
the Auth. Code text fields empty:
• Long Name - The name of the user, need to be unique throughout the system.
This is the name presented in a called party´s display, unless this is configured in
the IP-PBX.
• Name - The user name.
• Number - The phone number extension, need to be unique throughout the
system.
• Password - Optional, is used for registration towards the gatekeeper.
• Display Name - Will be showed in the Portable Device display when the Portable
Device is idle.
4 Click "OK".
5 Repeat step 2 to 4 for all users.
Assign Portable Devices to Users
1 Select DECT > System.