Operating instructions

TD 92579GB
2009-04-15/ Ver. B
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)
42
3 Configure LDAP replicator, enter the IP address, user name and password to the
LDAP server. Alternative LDAP server must not be entered. Select the Enable check
box, see
8.4.3 Configure LDAP Replicator on page 61.
4 Set a static IP address and set DHCP to off, see 8.2.2 Set a Static IP Address on page
57.
5 Set the mode to Standby Master, see 8.5.12 Select Mode on page 70.
6 Perform a reset to restart the IPBS/IPBL in Standby Master mode, see 8.16 Reset on
page 113.
7 Enter system name and password, this should be the same system name and
password as in the Master. See
8.5.1 Change System Name and Password on page
66.
8 Select supplementary services, see 8.5.11 Configure Supplementary Services on
page 69.
9 Set Master Id, see 8.5.13 Set Master Id on page 71.
10 Enter gatekeeper address, see 8.5.15 Configure Gatekeeper on page 71.
11 Connect to a Mobility Master, see 8.5.19 Connect Master to a Mobility Master on
page 73.
12 Enter IMS IP address, see 8.7.1 Configure Messaging on page 80.
13 Enter the Time Server address, see 8.1.4 Configure the NTP Settings on page 48.
14 Reset in order to make the configuration changes take effect, see 8.16 Reset on
page 113.
7.10 Plug and Play Configuration
Radios can be configured from the relevant Pari Master. When a new Radio is connected
to the system, it automatically registers itself as an uninitialized registration to all Pari
Masters in the system. It is possible to assign the Radio to one Pari Master. See Add Radios
on page 83.
7.11 Configure the Radio
This section describes how to configure the Radio. Each configuration step is briefly
described in the step list below, for more detailed information see the corresponding
subsection in 8 Operation on page 46.
Note: When one Radio is configured, the configuration can be saved and uploaded to the
other Radios in the system.
1 Determine the address and access the GUI, see 7.2 Access the GUI on page 31.
2 Change the default password, see 7.2.2 Change the Default Password on page 33.
3 Set DHCP mode to "Client", see 8.2.3 Dynamic IP address via DHCP on page 58.
4 Enable the Radio in the IPBS/IPBL, see
5 Enter Pari Master and Standby Pari Master IP addresses, see 8.5.21 Enter IP Address
to the Pari Master and the Standby Pari Master on page 74.
6 Configure air synchronization, see 8.5.25 Configure Air Synchronization on page
75.
7 Enter the Time Server address, see 8.1.4 Configure the NTP Settings on page 48.