Operating instructions

TD 92579GB
2009-04-15/ Ver. B
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)
41
9 Set Master Id, see 8.5.13 Set Master Id on page 71.
10 Enable Pari function, see 8.5.14 Enable Pari Function on page 71.
11 Enter gatekeeper address, see 8.5.15 Configure Gatekeeper on page 71.
12 Connect to a Mobility Master, see 8.5.19 Connect Master to a Mobility Master on
page 73.
13 Enter IMS IP address, see 8.7.1 Configure Messaging on page 80.
14 Enter the Time Server address, see 8.1.4 Configure the NTP Settings on page 48.
15 Reset in order to make the configuration changes take effect, 8.16 Reset on page
113.
7.8 Configure the Master
This section describes how to configure the Master. Each configuration step is briefly
described in the step list below. For more detailed information see the corresponding
subsection in 8 Operation on page 46.
1 Determine the address and access the GUI, see 7.2 Access the GUI on page 31.
2 Change the default password, see 7.2.2 Change the Default Password on page 33.
3 Configure LDAP user name and password, select the Write Access check box, see
8.4.1 Configure LDAP Server on page 60.
4 Set a static IP address and set DHCP to off, see 8.2.2 Set a Static IP Address on page
57.
5 Set the mode to Master, see 8.5.12 Select Mode on page 70.
6 Perform a reset to restart the IPBS/IPBL in Master mode, see 8.16 Reset on page
113.
7 Select system name and password, see 8.5.1 Change System Name and Password
on page 66.
8 Set default language, see 8.5.5 Set Default Language on page 67.
9 Select supplementary services, see 8.5.11 Configure Supplementary Services on
page 69.
10 Set Master id, see 8.5.13 Set Master Id on page 71.
11 Enter gatekeeper IP address or ID, see 8.5.15 Configure Gatekeeper on page 71.
12 Connect to a Mobility Master, see 8.5.19 Connect Master to a Mobility Master on
page 73.
13 Enter IMS IP address, see 8.7.1 Configure Messaging on page 80.
14 Enter the Time Server address, see 8.1.4 Configure the NTP Settings on page 48.
15 Reset in order to make the configuration changes take effect, see 8.16 Reset on
page 113.
7.9 Configure the Standby Master
It is recommended to have a Standby Master in the IP-DECT system. This section describes
how to configure a Standby Master. Each configuration step is briefly described in the step
list below, for more detailed information see the corresponding subsection in 8 Operation
on page 46.
1 Determine the address and access the GUI, see 7.2 Access the GUI on page 31.
2 Change the default password, see 7.2.2 Change the Default Password on page 33.