Operating instructions

TD 92579GB
2009-04-15/ Ver. B
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)
40
8 Change subscription method, see 8.5.2 Change Subscription Method on page 67.
9 Configure authentication code, see 8.5.3 Configure Authentication Code on page
67.
10 Select tones, see 8.5.4 Select Tones on page 67.
11 Set default language, see 8.5.5 Set Default Language on page 67.
12 Set frequency band, see 8.5.6 Set Frequency Band on page 68.
13 Enable carriers, see 8.5.7 Enable Carriers on page 68.
14 Enable local R-key handling, see 8.5.8 Local R-Key Handling on page 68.
15 Enable No transfer on hangup, see 8.5.9 No Transfer on Hangup on page 68.
16 Configure coder, see 8.5.10 Configure Coder on page 69.
17 Select supplementary services, see 8.5.11 Configure Supplementary Services on
page 69.
18 Set Master Id, see 8.5.13 Set Master Id on page 71.
19 Enable Pari function, see 8.5.14 Enable Pari Function on page 71.
20 Enter gatekeeper IP address or ID, see 8.5.15 Configure Gatekeeper on page 71.
21 Connect to a Mobility Master, see 8.5.19 Connect Master to a Mobility Master on
page 73.
22 Assign PARI, see 8.5.23 PARI on page 74.
23 Enter SARI, see 8.5.24 SARI on page 75.
24 Enter IMS IP address, see 8.7.1 Configure Messaging on page 80.
25 Enter the Time Server address, see 8.1.4 Configure the NTP Settings on page 48.
26 Reset in order to make the configuration changes take effect, see 8.16 Reset on
page 113.
7.7 Configure the Standby Pari Master
It is recommended to have a Standby Pari Master in the IP-DECT system. This section
describes how to configure a Standby Pari Master. Each configuration step is briefly
described in the step list below, for more detailed information see the corresponding
subsection in 8 Operation on page 46.
1 Determine the address and access the GUI, see 7.2 Access the GUI on page 31
2 Change the default password, see 7.2.2 Change the Default Password on page 33.
3 Configure LDAP replicator, enter the IP address, user name and password to the
LDAP server (Pari Master). Alternative LDAP server must not be entered. Select the
Enable check box, see
8.4.3 Configure LDAP Replicator on page 61.
4 Set a static IP address and set DHCP to off, see 8.2.2 Set a Static IP Address on page
57.
5 Set the mode to Standby Master, see 8.5.12 Select Mode on page 70.
6 Perform a reset to restart the IPBS/IPBL in Standby Master mode, see 8.16 Reset on
page 113.
7 Enter system name and password, this should be the same system name and
password as in the Pari Master. see
8.5.1 Change System Name and Password on
page 66.
8 Select supplementary services, see 8.5.11 Configure Supplementary Services on
page 69.