Operating instructions

TD 92579GB
2009-04-15/ Ver. B
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)
39
5 Write a login name and enter a password, see 8.5.17 Select Mobility Master Mode
on page 73.
6 Connect to other Mobility Master(s), see 8.5.18 Connect Mobilty Master to other
Mobility Master(s) on page 73.
7 Enter the Time Server address, see 8.1.4 Configure the NTP Settings on page 48.
8 Reset in order to make the configuration changes take effect, see 8.16 Reset on
page 113.
7.5 Configure the Standby Mobility Master
It is recommended to have a Standby Mobilty Master in a Multiple Master IP-DECT system.
This section describes how to configure the Standby Mobility Master. Each configuration
step is briefly described in the step list below. For more detailed information see the
corresponding subsection in 8 Operation on page 46.
1 Determine the address and access the GUI, see 7.2 Access the GUI on page 31.
2 Change the default password, see 7.2.2 Change the Default Password on page 33.
3 Set a static IP address and set DHCP to off, see 8.2.2 Set a Static IP Address on page
57.
4 Set the mode to Standby Mobility Master, see 8.5.17 Select Mobility Master Mode
on page 73.
5 Enter the primary Mobility Master IP address, see8.5.17 Select Mobility Master
Mode on page 73.
6 Write a login name and enter a password, this must be the same as in the primary
Mobility Master. See
8.5.17 Select Mobility Master Mode on page 73.
7 Connect to other Mobility Master(s). This should be the same Mobility Master(s) as
in the primary Mobility Master, see
8.5.18 Connect Mobilty Master to other
Mobility Master(s) on page 73.
8 Enter the Time Server address, see 8.1.4 Configure the NTP Settings on page 48.
9 Reset in order to make the configuration changes take effect, see 8.16 Reset on
page 113.
7.6 Configure the Pari Master
This section describes how to configure the Pari Master. Each configuration step is briefly
described in the step list below. For more detailed information see the corresponding
subsection in 8 Operation on page 46.
1 Determine the address and access the GUI, see 7.2 Access the GUI on page 31.
2 Change the default password, see 7.2.2 Change the Default Password on page 33.
3 Configure LDAP user name and password, select the Write Access check box, see
8.4.1 Configure LDAP Server on page 60.
4 Set a static IP address and set DHCP to off, see 8.2.2 Set a Static IP Address on page
57.
5 Set the mode to Master, see 8.5.12 Select Mode on page 70.
6 Perform a reset to restart the IPBS/IPBL in Master mode, see 8.16 Reset on page
113.
7 Select system name and password, see 8.5.1 Change System Name and Password
on page 66.