Operating instructions

TD 92579GB

2009-04-15/ Ver. B

Installation and Operation Manual

IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)

Note: After the first startup the DHCP mode should be changed from "automatic" to

either "client" or "off", see

8.2.1 Set DHCP Mode on page 57.

This section describes how to determine the dynamically allocated IP address. The address

is used to access the IPBS/IPBL using a web browser. Two methods are described:

• In a Network without a DHCP Server on page 32.

• In a Network with a DHCP Server on page 32.

In a Network without a DHCP Server

If the network does not have a DHCP server, and the DHCP mode is set to "automatic"

(factory default), follow the steps below.

Note: If the IPBS/IPBL has been used before, it must be restored to factory default settings

by performing a long hardware reset, see

8.17 Reset Using the Reset Button on page 113.

1 Connect a ethernet cable between the IPBS/IPBL and the computer.

Note: For IPBS, a power adapter must be used.

Note: For IPBL, make sure to use the LAN1 port.

2 Perform a hardware reset by shortly pressing the reset button.

3 The IPBS/IPBL will be assigned the IP address 192.168.0.1 and the netmask

255.255.255.0.

4 Enter http://192.168.0.1 in the browser address field to access the IPBS/IPBL GUI.

5 After the first startup the DHCP mode should be changed from "automatic" to

either "client" or "off", see

8.2.1 Set DHCP Mode on page 57.

In a Network with a DHCP Server

If the network has a DHCP server the IP address is determined following the steps below.

The IPBS/IPBL MAC address can be found on the label on the box and on the label on the

backside. The hexadecimal numbers (xx-xx-xx-xx-xx-xx) represent the MAC address.

Note: Make sure to use the LAN1 port for the IPBL.

Note: In order to determine the IP address using this method it is necessary to have a PC

with MS Windows. It must be connected to the same LAN (broadcast domain) as the IPBS/

IPBL.

Determine the IP address following the steps below:

Note: If the IPBS/IPBL has been used before, it must be restored to factory default settings

by performing a long hardware reset, see

8.17 Reset Using the Reset Button on page 113.

Then remove the power supply cable and connect it again.

1 Open a command window in windows by selecting Start > Run and enter "cmd" in

the Open: text field.

2 Enter the following commands:

C:\ nbtstat -R

C:\ nbtstat -a ipbs-xx-xx-xx (ipbl-xx-xx-xx)

Where xx-xx-xx should be replaced with the last 6 hexadecimal digits of the MAC-

address.