Operating instructions

TD 92579GB
2009-04-15/ Ver. B
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)
106
8.14 Update
This section describes how to do the following configurations and settings.
• Update Configuration
• Update Firmware
• Update the Boot File
• Update the RFPs
8.14.1 Update Configuration
A previously saved configuration can be loaded and activated on the IPBS/IPBL. See 8.12
Backup on page 103 for information on how to save a configuration.
1 Select Update > Config.
2 Click "Browse..." and browse to the saved configuration.
3 Click "Upload".
4 Reset in order to make the changes take effect, see 8.16 Reset on page 113.
8.14.2 Update Firmware
The software can be updated. Follow the steps below to update IPBS/IPBL with the
firmware. Download firmware from the IP-DECT system provider.
Note: If this operation is interrupted, the firmware in the device will be defect. If a
firmware upload is for any reason interrupted, the firmware must be uploaded again. Do
not execute a reset before the firmware upload is complete. For information on how to
load new firmware if the IPBS/IPBL is unreachable through the web GUI, see
10.1 Load
Firmware Using the Gwload Tool on page 116.
1 Select Update > Firmware.
2 Click "Browse..." and browse to the firmware file.
3 Click "Upload"
4 Reset in order to make the changes take effect, see 8.16 Reset on page 113.