Operating instructions

TD 92579GB
2009-04-15/ Ver. B
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)
104
8.13 Upgrade from IPBS/IPBL software version 2.x.x to 3.x.x
This section describes how to upgrade the IPBS/IPBL from software version 2.x.x to 3.x.x.
8.13.1 IPBS Upgrade
This section describes how to upgrade the IPBS from software version 2.x.x to 3.x.x.
1 Update the firmware to 2.4.0 or later. See 8.14.2 Update Firmware for more
information on how to update the firmware.
2 Reset in order to make the changes take effect, see 8.16 Reset.
3 Update the firmware to 3.x.x. See 8.14.2 Update Firmware for more information on
how to update the firmware.
4 Reset in order to make the changes take effect, see 8.16 Reset.
5 Update the boot file to 3.x.x. The new boot file version contains a built-in
webserver, so there is no need to use the Gwload tool (a tftp-style client used to
repair a broken firmware) if the IPBS is unreachable through the web GUI. See
8.14.3 Update the Boot File for more information on how to update the boot file.
6 Reset in order to make the changes take effect, see 8.16 Reset.
8.13.2 IPBL Upgrade
This section describes how to upgrade the IPBL from software version 2.x.x to 3.x.x.
1 Update the boot file to 413. See 8.14.3 Update the Boot File for more information
on how to update the boot file.
2 Update the firmware to 2.4.0 or later. See 8.14.2 Update Firmware for more
information on how to update the firmware.
3 Reset in order to make the changes take effect, see 8.16 Reset.
4 Update the firmware to 3.x.x. See 8.14.2 Update Firmware for more information on
how to update the firmware.
5 Reset in order to make the changes take effect, see 8.16 Reset.
6 Update the boot file to 3.x.x. The new boot file version contains a built-in
webserver, so there is no need to use the Gwload tool (a tftp-style client used to
repair a broken firmware) if the IPBL is unreachable through the web GUI. See
8.14.3 Update the Boot File for more information on how to update the boot file.
7 Reset in order to make the changes take effect, see 8.16 Reset.
8.13.3 Configuration
The following configuration settings should be changed in the GUI after updating the
firmware to version 3.x.x.
1 Disable LDAP replication for all Radios except in the case of Standby Master to
Master Replication. Select LDAP > Replicator and make sure that the Enable check
box is not selected.
2 Select DECT > Radio and enter the name and password for the Pari Master.
If the device is configured as a Master:
3 Select DECT > Master and select the Enable Pari function check box.
4 Select UNITE > SMS and enter the address to the IMS in the IP Address text box.
If SIP protocol is used: