Operating instructions

TD 92579GB
2009-04-15/ Ver. B
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)
4
Note: For more information about power distribution, see 5.3 Power the Base Station on
page 24.
Software
The software in the IPBS can be updated by downloading new software without
disconnecting the equipment. The new software is stored in flash memory. See 8.14
Update on page 106 for information.
Connectors
• Two 8-pin RJ45 modular jacks for LAN/PoE and powering
• A 6-pin RJ12 modular jack for factory testing
LEDs
Note: All amber statuses are warnings that Air synchronization, although still adequate, is
fading and might be lost. A flashing red indicates lost Air synchronization.
Status of LED1 (lower LED) Description
Steady Green Operational
Quick flashing amber Download of firmware in progress.
Steady Amber TFTP mode
Alternating red/green No Ethernet connection
Status of LED2 (upper LED) Description
Not lit IPBS operational and no traffic
Air synchronization OK
Steady green IPBS operational and traffic
Air synchronization OK
Slow flashing green Air synchronization OK and fully occupied with
traffic
Flashing amber Air synchronization adequate and no traffic
Slow flashing amber Air synchronization adequate and fully occupied
with traffic
Steady amber Air synchronization adequate and traffic
Flashing red No air synchronization - searching for air sync
candidates
Quick flashing red Download of RFP software in progress