Operating instructions

TD 92579GB
2009-04-15/ Ver. B
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 3.0.x)
101
If, by way of exception, the route for a Map entry is to be configured with a different
destination than that specified in the route's destination field, you can select this from the
Destination field of the “Map”.
Add CGPN map
1 Select Gateway > Routes.
2 For the interface, that you want to add a CGPN map, click the “->” sign under the
CGPN map heading.
Figure 44. Add CGPN map
A new window opens.
Figure 45. Number In – Number Out
3 Under “Number in” define the number type and –prefix that you wish to have
replaced. The number type is denoted using the abbreviation from the Call Number
Formats Table (see
Call Number Formats Table on page 95).
4 Define the substitution under “Number out”.
5 Click “OK”.
Note: All call numbers in IP-DECT are always processed in “unknown” format. That is
why the result of a number replacement for incoming calls, always is of the type
“unknown” and the call number type of outgoing calls to be replaced is likewise always
“unknown”. Accordingly, you cannot specify a number type for replacements of incoming
numbers in the “Number out” field and for replacements of outgoing numbers in the
“Number in” field.
8.11.6 Show Active Calls
Select Gateway > Calls.
On this page you can see the currently active calls on all configured gateway interfaces.
Calls from the IP-DECT Master does not normally display here.
The individual columns are explained in the table below.
Figure 57.
Figure 58.
Column Format Values Description