Specifications

TD 92326GB

2009-03-10 / Ver. E

Installation and Operation Manual

VoIP Gateway

1 Select PBX > Calls.

Figure 63. Shows active calls

A complete call with two subscribers is displayed on each line. The data of the first

subscriber is displayed in the first three columns (E164, H323 and Media), the call direction

is specified in the fourth column (Dir) and the data of the second subscriber is displayed in

the following three columns (E164, H323 and Media).

The call status is indicated in the last column (State). The calling party is generally referred

to as the first subscriber, the called party as the second subscriber. The Calls list is updated

approximately every fifth second.

See also 12.6.5 Show Active Calls on page 100.

11.7 SOAP – Display Active Sessions

Note: Not supported by Ascom.

Figure 71.

Field name Description

• Number The calling number

• Name The calling name

• Protocol Used protocol on the calling side

• Media Announcement of the Coder used on the calling side. For example

G711AB (2,0,0). The values in parentheses mean in order:

• round trip (blank) = running time of a packet from A to B and

back again.

• jitter = latency (time interval from the end of an event up to the

beginning of the reaction).

• loss (PL) = number of missing packets (Packet Loss).

• Dir In the condition alerting “>”. and in the condition connected “>>”.

• Number The called number

• Name The called name.

• Protocol Used protocol on the called side

• Media Used Coder on the called side

• Uptime The call uptime

• State Possible conditions: Alerting, Calling, Connected, Disconnecting.