Specifications

TD 92326GB

2009-03-10 / Ver. E

Installation and Operation Manual

VoIP Gateway

11.4.2 View Configured Objects

1 Select PBX > Object.

2 Click “Show”.

Figure 59. Show configured objects

All configured objects, call groups, etc. currently registered to the PBX Application are

shown in a list.

• Long Name is the full name. This is the name that is sent for Caller Name to another

VoIP client, or over the PRI to a PBX.

• Name is the name shown in the idle display on the VoWiFi handset, for example

J. Smith for a subscriber. Recommended to keep this at 12-14 characters to keep the

Name and Extension displayed on the VoWiFi handset.

• No is the phone number for the subscriber or call group

• URL is used if you want to send a voice mail as an attached Wave file to a voicemail

box. Note that only one transmission attempt per email will be performed.

• HW-ID is the hardware ID

• Node is to which node the subscriber and call group belongs

• PBX matches the name entered under PBX > General

• Filter is the Call filter defined for the subscriber or call group

• Groups is to which group the subscriber belongs

• CF* shows Call Diversions

• Config shows if a template is used for this user.

• Rights is used to set access rights

• Type shows type of object

• No Inband

Disconnect

If set, a call disconnect with inband information will not be

forwarded to the endpoint registered to the user, but the call

will be cleared immediately without the inband information

being sent.

• Group Indications You can select a group of which the object is to become a

member, provided you have already defined a group.

The object must be active member in this group. The other

objects (for which group indications are sent) need not to be

active. To monitor other endpoints on a phone with a

Partner/Pickup function key group indications are needed for

the endpoints. The maximal length of the Group Indication

Name in V7 is set to 48 characters.

Figure 67.