Specifications

TD 92326GB
2009-03-10 / Ver. E
Installation and Operation Manual
VoIP Gateway
64
3 Click “OK”.
The lower area of the window shows installed licenses, the number of VoIP clients allowed
by the license, and the number of VoIP clients currently registered to the VoIP Gateway.
11.1.1 Create Personalized Music on Hold.
1 The MOH file(s) that you want to use in the Gateway must be created or converted
into a standard 8 kHz, 16 bit, mono wave file(s).
2 You will need the softcod.exe tool (obtainable from the manufacturer).
3 Place the softcod tool and the .wav file in the same directory.
4 Launch the tool “softcod <filename.wav>” (note replace <filename> with the
actual name of your file).
5 You will receive a prompt from the gateway asking for the gatekeeper alias. Enter
“erwin”.
6 Four files will be generated <filename.g711a>, <filename.g711u>,
<filename.g723>, <filename.g729>. Only the .g729 file will be used by the
gateway. Place that file on an accessible fileserver.
•
Escape Dialtone from Enter the long name of the PBX object to which a call
is made to get a dialtone if a dialtone is configured for
the escape of a node. This object must be assigned to
this PBX Application.
Slave PBX
(shown in Slave mode)
• Master – the IP address of the PBX master.
• Alternate Master – the IP address of an alternative
PBX master (standby, if available).
• Password – the password to be used for registration
at the Master as configured in the Node Object.
• Route Master calls if no Master to – if the master is
not available, master calls are sent to this destination.
• Max Calls to Master – can be used to limit the calls
to the master. If a call is sent to the master and there
are already calls to/from the master equal to or
exceeding this value, the call is handled as if the
master was not available.
Standby PBX
(shown in Standby mode)
• Master – the IP address of the PBX master.
Standby-Slave PBX
(shown in Standby-Slave
mode)
See Slave PBX and Standby PBX above.
Licences
A list of all installed PBX license with their current
usage.
• Count: The total number of installed licenses of this
type.
• Usage: The total usage of this license type
• Local: The usage of this license on this PBX
• Slaves: The usage of this license on PBX's registered
to this PBX.
Registrations
The Limit row shows how many registrations the
license is valid for, and the Current row shows the
number of VoIP clients currently registered.