Specifications

TD 92326GB
2009-03-10 / Ver. E
Installation and Operation Manual
VoIP Gateway
63
• System Name Enter a name, for example the location of the PBX
interface. The name identifies the local PBX and
should be the same as configured in the PBX object.
If a system name is added, remember to add PBX
users. For H.323 end-points this is the Gatekeeper
identifier.
• PBX Name This name identifies the local PBX. It should be the
same as configured in Objects with the type “PBX”.
This is optional and normally not necessary. But if an
ID is assigned it must be different from all other
gatekeeper ID entries in other PBX configurations and
gatekeepers defined.
• Unknown Registrations If checked unknown registrations (useful for
deployment of new endpoints) are accepted.
• Music On Hold URL Enter the URL to be used for music on hold (MOH).
See 11.1.1 Create Personalized Music on Hold.
For disabling MOH, enter “off” in the text field.
• External Music On Hold Configure an H.323 name. This name is used by an
external music on hold source to register at the PBX.
• Response Timeout The time limits (in seconds) for call diversions in the
event of no response, for all users. Individual CFNR
timeout will override this setting.
• Dial Complete Timeout Global timeout (in seconds) after which any action for
incomplete dialled number is taken (for example
incomplete destination at trunk object).
• No of Regs w/o Pwd. Defines how many times a VoIP client can register
without entering a password.
Set to 0 to deny registrations without password.
• Recall Timeout Limitation for recalling can be set here in seconds (if
the subscriber not responds).
• Enable External Transfer If not enabled a transfer between two external end-
points is prohibited.
• RTP Proxy If checked, all media traffic is routed via the PBX
Application. Only use if needed, since it creates CPU
load on the PBX Application.
• Generate CDRs If checked, the PBX generates CDRs for all calls.
• Route Root-Node
External Calls to
(available on the Master
or Standby PBX only)
Enter the long name of the Root object as destination
for external calls. Any call call which cannot be
terminated inside the PBX Application is sent to this
destination as long as neither the source nor the
destination of the call can be associated with a node
with a PBX configured. This object must be assigned
to this PBX Application.
• Route PBX-Node External
Calls to
Enter the long name of the PBX object created as
destination for external calls. Any call call which
cannot be terminated inside the PBX Application is
sent to this destination as long as the source nor the
destination of the call can be associated with the
node of this PBX Application. This object must be
assigned to this PBX Application.