Specifications

TD 92326GB

2009-03-10 / Ver. E

Installation and Operation Manual

VoIP Gateway

8.3 Replicator – Configuration

The task of LDAP replication is to copy and keep up to date the content of the user

database.

LDAP Replicators are usually configured in the following cases:

• User data is replicated from the Master VoIP Gateway to the Standby or Slave VoIP

Gateway The replicator is configured on the Standby or Slave VoIP Gateway (Full

Directory Replication).

The same user name and password specified in the “master” VoIP Gateway (LDAP

Server) must be entered here. The LDAP user and password is stored in Configuration >

LDAP > Server".

• User data is replicated from the Active Directory (AD) to the Master. The replicator is

configured on the Master.

1 Select LDAP > Replicator.

2 Select Type, either "Full Replication" or "Active Directory replication".

3 Select/Enter the following settings.

rx-del Number of received delete inquires

rx-abandon Number of received abandon inquires

tx-notify Number of transmitted notifications

tx-error Number of transmit errors

tx-error-49 Number of transmit errors due to incorrect entrance data

tx-error-50 Number of transmit errors due to insufficient rights

Field name Description

Full Replication

•Enable Start/Stop the replication.

•Server The LDAP server “IP address”.

•Alt. Server If an alternative LDAP server is used enter its “IP address”.

•Filter Type Select whether an internally required LDAP Filter will be

derived from a PBX Name or is to be entered free-hand.

•BPX Name Depending on selection of Filter Type, enter either the name

of the PBX Application or the name of an LDAP Filter.

•User Enter the user name specified in the LDAP server.

•Password Enter the password specified in the LDAP server.

Active Directory Replication

•Enable Start/Stop the replication.

•Server The IP address of the remote Active Directory.

•DN The distinguished Name of the search base. This DN must be

one of the naming contexts, offered by the remote Active

Directory. If the Server setting was entered, the Show..

button will show which naming contexts are available. In

most cases the default naming context will be selected and

can be "OK".

•LDAP Filter An LDAP Filter according to RFC2254. A default is offered.