Specifications

TD 92326GB

2009-03-10 / Ver. E

Installation and Operation Manual

VoIP Gateway

3 Click “OK”.

7.3 NAT – Network Address Translation

Note: Not supported by Ascom.

1 Select ETHX > NAT

Figure 32. NAT configuration

2 Select/Enter the following settings.

3 Click “OK”.

7.4 VLAN – Priority

Configure the VLAN ID only if the system supports VLAN tagging (IEEE 802.1q). The switch

used must be configured as a trunk port. For priority tagging (802.1p) it is sufficient to

configure the priority value only.

1 Select ETHX > VLAN

Figure 33. VLAN ID and priority

•

Network destination

Network mask

– For network routes, enter the Network address with the

host part as 0 in the Network dest. text field, and enter the

correct Network mask in the Network mask text field.

– For host routes enter the complete IP address of the host

in the Network dest. text field, and enter 255.255.255.255

in the Network mask text field.

• Gateway Enter the name of the Gateway

Figure 32.

Field name Description

• Include interface

in NAT

Enable if used, see B.1 NAT and Firewalls on page

165.

• Exclude Address Enter IP address to be excluded from NAT

• Exclude Mask Enter Subnet mask to be excluded from NAT,

Figure 33.