Specifications

TD 92326GB

2009-03-10 / Ver. E

Installation and Operation Manual

VoIP Gateway

3 Upload the software in the steps given below, refer to 14.2 Upload New Firmware

on page 104 and 14.3 Upload New Boot Code File on page 105.

1) Upload version 6.00 and reboot by clicking the "Reset..." link.

2) Upload version 7.00 and reboot.

3) Upload the Boot Code file and reboot.

4) Upload version 7.00 again and reboot.

4 Update the licence, follow the instructions in 4.1.2 below.

4.1.2 Update the Licence

1 Enter the Ascom Extranet and select Supply > License > Licence.

2 Select "Review Existing Licence" and click "OK".

3 Select License Type "IGWP".

4 Enter your MAC address in the Search text field and click "Search". A new page

opens.

5 Click on the row that shows MAC Address, Customer name and Date. The Licence

page opens.

6 Click "Download License" to open the File Download window.

7 Click "Save" to download the .txt file and save it where you later can find it.

8 Add the .txt file to the VoIP Gateway, refer to 5.3.1 Add License on page 15.

4.2 Upgrade from version 1.01 or earlier, to version 1.2.x

There is a number of configuration changes between 1.01 and 1.2.x.

4.2.1 Gateway Object (former EXTERN object)

A call that cannot be terminated in the PBX, will now be sent by the PBX to a pre-

configured Gateway object. This Gateway object can be compared to the previously

automatically created EXTERN object. The Gateway object can take multiple registrations,

contrary to the EXTERN object that could only take one registration.

The new parameter PBX/General/”Route External calls to” is used for setting which

Gateway object shall be used for routing calls that cannot be terminated in the PBX.

Figure 5.