Specifications

TD 92326GB
2009-03-10 / Ver. E
Installation and Operation Manual
VoIP Gateway
121
5 Enter “IP Address”, subnet “Network mask”, “Default gateway” and “DNS server”
address in the text fields.
Figure 106. Set static IP address
6 Click “OK”.
7 Now start the web-based configuration, using the new IP address.
B. With a fixed IP address via DHCP
1 Select ETH0 > DHCP.
2 Select “Client” in the Mode drop-down list.
Figure 107. Set DHCP to Client
3 Click “OK”.
4 Now start the web-based configuration, using the new IP address.
You can display the allocated IP address with NetBIOS over TCP/IP as follows.
In the command line, enter C:> plus the following command:
nbtstat –R
nbtstat –a IGWP-XX-XX-XX. l
Where the Xs should be replaced with the last 6 hexadecimals in the
VoIP Gateway's MAC address, see 2.7 The MAC Address on page 6.
17.3.5 PRI (Primary Rate Interface) Settings
The VoIP Gateway has four PRI interfaces, 2×TE mode for trunk interface, or 2×TE and
2×NT mode to insert in trunk lines. The PRI interfaces are default in TE (Terminal) mode but
can be set in NT (Network) mode. For more information refer to chapter 22.3 The TE and
NT modes on page 154.
This example: A PRI protocol must be selected and the PRI1 interface needs to be
connected to the PBX. If more than 23 channels are needed, connect PRI3 as well for a
total of 46 channels.
Figure 101.