Specifications

TD 92326GB
2009-03-10 / Ver. E
Installation and Operation Manual
VoIP Gateway
110
15.2.3 Events – Show all Events
1 Select Diagnostics > Events.
All events are shown in a list. The list can be deleted by clicking the Clear link.
Figure 93. Show all events
Figure 98.
Alarm Code Description
0x000a0001 Signalling error reported by ISDN interfaces: A broadcast packet was
received on a point-to-point interface, which should not happen. This
indicates that there is a configuration mismatch point-to-point/point-to-
multipoint.
0x00090001 The cluster chain of a file or a directory is broken. This can be caused by
removing the card without dismounting it before. Be sure to run chkdsk
0x00090002 The next cluster of a file or a directory is out of range. This error should
not occur. Be sure to run chkdsk
0x00090003 The underlying driver returned no data. This can be caused by an invalid
cluster or if the card was removed while operations are performed on it.
Be sure to run chkdsk
0x00090004 The card is full. You can buy a bigger one or delete some unnecessary
files.
0x00090005 The card is unformatted or formatted with an unknown format. Be sure
to format it with fat32.
0x00090006 The card has a wrong disk format. The needed format is fat32.
0x00050002 RTP: Excessive Loss of Data. This event is generated if in a period of 10s
more than 3 RTP packets were lost.
0x00010003 Protocol error. The gateway process receive a call clearing with cause code
'Protocol Error'. This can be an indication for an interop problem with
some other equipment.
0x00070003 The SIP protocol stack reached its build-in memory allocation limit. The
total number message allocations is limited to be save against denial-of-
service attacks. Under normal working conditions the limit should not be
reached.