Specifications

TD 92326GB
2009-03-10 / Ver. E
Installation and Operation Manual
VoIP Gateway
96
6 Click “OK”
If, by way of exception, the route for a Map entry is to be configured with a different
destination than that specified in the route's destination field, you can select this from the
Destination field of the “Map”.
12.5.1 Add CGPN map
1 Select Gateway > Routes.
2 For the interface, that you want to add a CGPN map, click the “->” sign under the
CGPN map heading.
Figure 75. Add CGPN map
A new window opens.
Figure 76. Number In – Number Out
3 If a "GK Reg. Name" is configured, the mapping is applied only if the call is
received from a Gatekeeper/Registrar interface and the name configured for the
registration matches this name.
• Rerouting on Diverting No If set the route only matches to an incoming diverting
number instead of a called party number. If the
diverting number matches the called party number it is
replaced by the diverting number and the diverting
number is removed and the call is routed normally.
• Force enblock Used to convert a call from overlap dialing to enblock
dialing. The call is not sent until for a timeout of 4s no
additional dialing digit is received. See 21.12 Enforce
en-bloc dialling on page 150.
• Add # A # can be transmitted to mark the end of the call
number. This is required for devices, such as from
Cisco, which are unable to identify the end of a
number properly.
• Disable Echo Canceler see 21.14 Suppress Echo Compensation on page 150.
• Call Counter Call Counters can be used to limit the calls sent
through the given route. If the same Call Counter (any
Name) is configured for several maps, each active call
sent through such a map is counted with the Call
Counter. A name for resource management can be
entered. See 21.15 Resources Management on page
150.
• Max Limits the number of permitted calls for a route. See
21.15 Resources Management on page 150.
Figure 84.
Figure 85.