User's Manual
Table Of Contents
- Contents
- Index
- 1. Introduction
- 2. Safety Instructions
- 3. Description
- 4. Getting Started
- 5. Settings
- 6. Using the Ascom Myco Launcher
- 7. Alert View
- 8. Conversation
- 9. Calling
- 10. Phonebook
- 11. Camera and Gallery
- 12. Apps
- 13. Operation Notice
- 14. Maintenance
- 15. Troubleshooting
- 16. Related Documents
- 17. Document History
- Appendix A. Advanced and Admin System Settings
- Index
- Index
TD 93066EN
2 April 2015 / Ver. A
User Manual
Ascom Myco SH1 Wi-Fi and Cellular Smartphone
38
13. Operation Notice
13. Operation Notice
13.1 Accessibility and Voice Quality
The WLAN network is not always available. If you do not get in contact with your system,
contact your system administrator. For best voice quality, avoid positioning near computer,
radio or similar equipment.
13.1.1 Operating Area
The handset can only be used in the area that is covered by the system. Outside this area
the handset lose contact with the system. The signal strength icon is low. The Notification
bar shows more information about the warning.
13.1.2 Out of Range (No network)
When you leave the area that is covered by the system, the handset will, by default indicate
with a short beep, and the text "Warning" appears in the top display in idle mode. To switch
the beep of, press once on "Volume" button Down.
The indication is by default repeated every minute for 30 minutes.
When re-entering the coverage area, it can take a couple of minutes before the handset
automatically has registered in the system.