User's Manual
Table Of Contents
- Contents
- Index
- 1. Introduction
- 2. Safety Instructions
- 3. Description
- 4. Getting Started
- 5. Settings
- 6. Using the Ascom Myco Launcher
- 7. Alert View
- 8. Conversation
- 9. Calling
- 10. Phonebook
- 11. Camera and Gallery
- 12. Apps
- 13. Operation Notice
- 14. Maintenance
- 15. Troubleshooting
- 16. Related Documents
- 17. Document History
- Appendix A. Advanced and Admin System Settings
- Index
- Index
TD 93066EN
2 April 2015 / Ver. A
User Manual
Ascom Myco SH1 Wi-Fi and Cellular Smartphone
13
4. Getting Started
4. Getting Started
The following chapter describes how to start using the handset. Read it through, before
using the handset for the first time.
4.1 Quick Steps for System Administrators:
Perform the following steps to get the handset started:
NOTE: Remove the protective plastic sheet that is attached to the display at delivery, before
using the touchscreen to ensure proper function.
1 Insert the Micro-SIM (for the Cellular version only). Refer to 4.2 Insert SIM Card on
page 13.
2 Close the battery cover, and lock it.
NOTE: If desired, change the language. Enter the handset ID (Easy deployment). If not
already done as prerequisite, perform Easy deployment. Refer to the Configuration
Manual.
3 If desired, configure parameter settings for the site, or user. Refer to the
Configuration Manual.
4.2 Insert SIM Card
NOTE: Cellular only.
1 If needed, unlock the battery cover, and remove it.
2 The SIM card slot is located under the clip. Press on the clip to open it fully, and insert
the Micro-SIM in the SIM card slot, in the direction as shown on the label.
TIP: If needed, use a tweezer to hold it, then push it into the slot.
3 Close the battery cover, and lock it. The handset starts within seconds if the battery is
charged.
TIP: If the handset does not start, charge the battery, and then long press the Power
button to switch the handset On.
4.2.1 Remove SIM Card
1 Open the battery cover lock. Press on the clip to open it fully, and remove the Battery
Pack.
2 Remove the SIM card by using a 3-4 mm screwdriver, or similar tool, in the hole above
the SIM card slot, and pull outwards, until the SIM card can be removed (with your
fingers, or a tweezer).
NOTE: Be careful not to damage the inside of the SIM card slot.
4.3 Easy Deployment
A handset is automatically installed and configured, if the VoWiFi system is configured for
Easy Deployment. Refer to the Configuration Manual.
If the VoWiFi system is not automatically installed and configured, do as follows.
1 If the handset is switched On, switch it Off and then On again.