User's Manual

TD 93066EN
2 April 2015 / Ver. A
User Manual
Ascom Myco SH1 Wi-Fi and Cellular Smartphone
7
2. Safety Instructions
2.3 Regulatory Compliance Statements (USA and Canada only)
FCC ID:
SH1-ABAA: BXZSH1B
SH1-ACAA: BXZSH1C
IC:
SH1-ABAA: 3724B-SH1B
SH1-ACAA: 3724B-SH1C
2.3.1 FCC and IC Compliance Statements
This equipment has been tested a
nd found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate t
he receiving antennas.
• Increase the separation between the e
quipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technici
an for help.
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la Classe B conforme á la norme NMB-003 du
Canada.
Privacy of communications may not be ensure
d when using this handset.
2.3.2 Exposure to Radio Frequency Signals
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled
environment. This device complies with FCC SAR limit of 1.6 W/kg. The maximum SAR value
measu
red, see below.
Head Body
SH1-ACAA 0,580 W/kg 1,229 W/kg
SH1-ABAA 0,405 W/kg 0,544 W/kg
The handset is designed to be worn with the display towards the b
ody for best radio
performance. In this position, the SAR testing is made with no separation, to approve the
device to be carried close to the body.
For other body worn usage, for example, with the clip towards the body, the SAR te
sting is
made with 0 mm separation. The device should be carried at least this distance away from
the body to meet the requirements of the RF exposure levels. This device must not be co-
located or operating in conjunction with any other antenna or transmitter.
Use of non-Ascom approved accessories may violat
e the FCC and IC guidelines for RF
exposure and should be avoided.