User's Manual
Table Of Contents
- Contents
- 1 Introduction
- 2 Descriptions
- 3 Operation
- 3.1 Basic Operation
- 3.1.1 Call List
- 3.1.2 Make a Call
- 3.1.3 Answer a Call
- 3.1.4 End a Call
- 3.1.5 Transfer a Call
- 3.1.6 Turn Off Alert Signals at an incoming Call
- 3.1.7 Turn the Mute Mode during a Call Off/On
- 3.1.8 Loudspeaking Function
- 3.1.9 Increase/Decrease the Speaker Volume during a Call
- 3.1.10 Turn Audible Signals On/Off
- 3.1.11 Lock/Unlock the Keypad
- 3.1.12 Lock/Unlock the Handset
- 3.1.13 Switch the Handset On
- 3.2 Messaging
- 3.3 SMS (Short Message Service)
- 3.4 Interactive Messaging
- 3.5 Mobile Data
- 3.6 Conference Call
- 3.7 Push-to-talk
- 3.8 Alarm Operation
- 3.9 Automatic Call after an Alarm
- 3.1 Basic Operation
- 4 Navigate the Menu
- 5 Menu Tree
- 6 Menu Operation
- 6.1 Messages
- 6.2 Contacts
- 6.2.1 Find an Entry in the Local Phonebook
- 6.2.2 View an Entry in the Local Phonebook
- 6.2.3 Add an Entry to the Local Phonebook
- 6.2.4 Delete an Entry in the Local Phonebook
- 6.2.5 Edit an Entry in the Local Phonebook
- 6.2.6 Find an Entry in the Central Phonebook
- 6.2.7 Save a Number from the Call List to the Local Phonebook
- 6.2.8 Delete a Number in the Call List
- 6.2.9 Delete All Numbers in the Call List
- 6.3 Modes
- 6.4 Services
- 6.5 Settings
- 6.5.1 Change the Volume
- 6.5.2 Change the Ring Signal
- 6.5.3 Key Beep On/Off
- 6.5.4 Vibrator On/Off
- 6.5.5 Deactivate/Activate No-movement alarm
- 6.5.6 Deactivate/Activate Man-down alarm
- 6.5.7 Deactivate/Activate Pull-cord alarm
- 6.5.8 Edit a Soft key
- 6.5.9 Edit a Hot key
- 6.5.10 Select Language
- 6.5.11 Change Text Size
- 6.5.12 Lock the Handset Manually
- 6.5.13 Change the Lock Code
- 6.5.14 Clock Settings
- 6.5.15 Turn On/Off Automatic Keypad Lock
- 6.5.16 Enable/Disable Quick Answer
- 6.5.17 Set New Messages to be Displayed Upside down
- 6.5.18 Set Owner ID
- 6.5.19 Select PBX System
- 6.6 Additional Information
- 7 Advanced Functions
- 8 Operation Notice
- 9 Maintenance
- 10 Trouble Shooting
- Appendix A: 9d24 Mkll Functionality with a 9d23 SIM
- Index 92333GB
PRELIMINARY
TD 92333GB
2006-03-20/ Ver. PA8
User Manual
9d24 Mkll Cordless Telephone
44
Note: It is not possible to charge spare batteries in the Desktop Charger.
9.2 Remove the Battery
The battery is fastened by a screw and two hooks. To remove the battery, use a small coin
and turn the screw to horizontal position. Remove the battery by pulling the screw. When
fastening the battery again the screw has to be in horizontal position.
Note: Avoid using a screwdriver as it may damage the screw.
9.3 Change the SIM Card
Remove the battery as described above. Slide the SIM card out of position. Insert the new
SIM card and slide it into position.
9.4 Change the Clip
A hinge-type belt clip is mounted on the 9d24 Mkll Cordless Telephone at delivery. The clip
can be replaced with a covering plate that is in the delivery or a swivel-type belt clip that
can be ordered separately.
Tools required:
• Pozidriv Point size 1
9.5 Attach Pull-cord Protection Plug
Disable the pull-cord alarm, see
6.5.7 Deactivate/Activate Pull-cord alarm on page 32.
Remove the pull-cord and replace it with the Protection plug.
10 Trouble Shooting
Problem Solution
The handset do
not start
Check that the correct battery type is used. "Only to
be used in RAID2-XXXXX" should be printed on the
label on the battery. If the battery is correct make sure
it is fully charged.