User Guide

8 ascom Office 10 20316549en_ba_a0
Appliance functions
LED display
The handset is on-hook:
Setting the handset volume
You are making a call:
There are four volume levels.
Activating/deactivating the programming mode
To make the following settings you need to activate the programming
mode:
The handset is on-hook:
Now adjust the settings. Once you are finished, deactivate the pro-
gramming mode once again:
The programming mode is activated:
Using the memory locations 0 to 9 (private directory)
Your telephone set has 10 memory locations, under which you can store
any call numbers or functions of your choice:
The programming mode (
+Activating/deactivating the programming
mode) is activated:
LED lit:
• A caller was unable to reach you and asks you to call
him back (
+Answering the callback).
• A subscriber used *38 to activate the LED (
+Other
functions) and asks you to call him back (+Answering the
callback)
LED flashing slowly:
Telephone is not logged in (
+Installation)
LED flashing quickly:
Call pending (
+Answering a call)
Quieter.
Louder.
(Keep pressing the key until you hear an acknowledge-
ment tone.)
1
2
A
B
C
You hear the idle tone (+ Glossary).
You no longer hear the idle tone.
The programming mode is activated.
(Keep pressing the key until you hear the acknowledge-
ment tone.)
The programming mode is deactivated.
. . . Select a memory location.
Key in the call number or function
of your choice.
or Confirm the new setting and save.
The previous setting is retained.
0
9
W
X
Y
Z
☛
END
END