Installation Guide

PRELIMINARY
Mounting
INSTALLATION GUIDE
Wireless Pull Cord Module (NUWPC3–Hx)
3. Insert the battery connector (See Figure 1. NUWPC3 Base Orientation and mounting, page 3, item 4)
into the socket on the rear side of the module.
4. Place the module on the gasket and make sure it fits neatly.
5. Use the 2 provided screws and a Phillips screwdriver to screw the module onto the holes in the spacer
(See Figure 1. NUWPC3 Base Orientation and mounting, page 3, item 3). Tighten the screws, but do not
over tighten them.
6. Connect the bottom half of the cord to the part coming from the module. The two halves should firmly
click together.
5 TD 93427EN / 30 October 2020 / Ver. PA4