PRELIMINARY INSTALLATION GUIDE Wireless Pull Cord Module (NUWPC3– Hx)
PRELIMINARY INSTALLATION GUIDE Wireless Pull Cord Module (NUWPC3–Hx) Introduction 1 Introduction 1.1 Symbols Read the manual for more information Caution: Use extreme caution and follow instructions carefully. 1.2 Description The Wireless Pull Cord Module NUWPC3 communicates with the controller (NIRC3/NIRC4) or a repeater (NUREP). The NUWPC3 pull cord is battery powered with two AA Alkaline batteries. The batteries can be easily replaced using the battery pack via the battery door in the spacer.
PRELIMINARY INSTALLATION GUIDE Wireless Pull Cord Module (NUWPC3–Hx) 1.5 Introduction Regulatory Compliance US/CAN For further information about the teleCARE system products see “System Description” TD93025, where also information regarding Regulatory compliance can be found. TD 93427EN / 30 October 2020 / Ver.
PRELIMINARY INSTALLATION GUIDE Wireless Pull Cord Module (NUWPC3–Hx) Mounting 2 Mounting The base of the NUWPC3 mounts directly onto flat wall or ceiling surfaces. Caution: To prevent a fire hazard because of dust buildup inside the NUWPC3, regular inspection and/or cleaning of the NUWPC3 is required. Caution: Take proper measures to avoid spreading dust and other particles when applying maintenance to an NUWPC3 that is mounted inside a clinical area. 2.
PRELIMINARY INSTALLATION GUIDE Wireless Pull Cord Module (NUWPC3–Hx) Mounting To mount the NUWPC3 base on a wall 1. Place the base against a flat wall and orient it so that the battery door is pointing down and that the base is level. Or place the base against the ceiling. Use a leveling device to check, if necessary. 2. Make sure that there is room to remove the battery pack from the base before mounting the base. (SeeFigure 1. NUWPC3 Base Orientation and mounting, page 3, item 2.) 3.
PRELIMINARY Mounting INSTALLATION GUIDE Wireless Pull Cord Module (NUWPC3–Hx) 3. Insert the battery connector (See Figure 1. NUWPC3 Base Orientation and mounting, page 3, item 4) into the socket on the rear side of the module. 4. Place the module on the gasket and make sure it fits neatly. 5. Use the 2 provided screws and a Phillips screwdriver to screw the module onto the holes in the spacer (See Figure 1. NUWPC3 Base Orientation and mounting, page 3, item 3).
