Installation Guide

PRELIMINARY
INSTALLATION GUIDE
Wireless Pull Cord Module (NUWPC3–Hx) Mounting
• Remove the battery pack from the base (item 2). The battery pack is kept in place by a small edge. Lift
the pack over this edge.
2. Remove the 2 screw caps:
• Insert a small flat tipped screwdriver next to the cap (item 1).
• Twist the screwdriver and pop out the cap (item 2).
3. Remove the 2 screws with a #2 Phillips screwdriver.
4. Pull the Module gently away from the base. The module is still connected to the base via the battery
pack wires.
5. Disconnect the battery connector from the rear of the module
TD 93427EN / 30 October 2020 / Ver. PA4 8