User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 94
Installation Guide
teleCARE IP
The connections of the passive bus wires is shown in the following illustration.
Figure 121. 4-pole connector terminal with the passive bus
The illustration below shows the location of the passive bus connector:
Figure 122. Passive bus connector location
6.12.11 Mounting the NIPC2 Pull Cord Module to the Backplate
The method described for mounting the switch module to the backplate is basically the same for the
active and the passive pull cord switch modules. The following illustration shows the back plate
mounted on the back box with the cable pulled through and connected to the 4-pole connection
terminal.
5.5Vdc
(Aux) IN0
(Aux) IN1
(Aux) OUT
4-Pole
Connector
for the
Passive
Bus