User's Manual

TD 93021US Rev A
10 FEB 2014 / Ver A 63
Installation Guide
teleCARE IP
Figure 68. Mounting the backplate (or spacer) on the back box
The backplate should be placed over the back box with the side marked “TOP” at the top. Then turn
the backplate so that the heads of the screws pass through the eyes of the appropriate “key-hole”
slots (1). The backplate must then be turned (2) until the side marked “TOP” is up. Finally the back
box screws should be tightened (3).
Figure 69. Securing the backplate (or spacer) to the back box
6.3.2 Surface Mounting Spacer
The surface mounting spacer is available for surface mounting the teleCARE IP bgv switch modules,
with or without a back box. The spacer can be mounted directly on to a flat wall surface or
alternatively, the holes in the base of the spacer allows it to be mounted over various international
back boxes.